REMOVING TUB OVERFLOW COVER HOW TO

Convinced of this, I replaced a couple of faucet valves, tightened some threaded connections, and sealed a couple different drain connections with silicone tape, yet I still had a leak. It didn’t make sense to me that the overflow drain got enough water exposure to be the source of a leak which was ruining a drywall ceiling downstairs. You wouldn’t think a bathtub overflow drain would be the source of a water leak, especially if you never fill the tub to a level at which water would enter the opening. Alternative Heating & Fireplace InsertsĪ simple leaky gasket can cause a big problem.We immediately respond to and handle any emergency plumbing, drain cleaning, and water damage problem, including excavation of underground water lines and sewer main lines.

If you need more help cleaning out your plunger-style trip lever tub drain, don’t hesitate to contact us or call us at 1-Tom-Plumber (1-86).

REMOVING TUB OVERFLOW COVER HOW TO

How to Use a Drain Snake to Unclog a Sink.

2 Tips on How to Clean Hair Out of Your Bathroom Sink Drain.

5 Ways to Clean Hair Out of Your Shower Drain.

Here are some great articles that can help you with any clogged tub and shower drain: Not all mechanisms work the same but you can feel confident that this cleaning method works extremely well for trip lever tub drains that are clogged with hair or other debris.

There are many styles of tub drains on the market, from Lift-and-Turn and Push-and-Pull to Toe Touch, Flip It and Trip Lever. The diagram (left) and photo (right) indicate how all the pieces of the trip lever (plunger-style) drain assembly connect and work together to form the mechanism that allows you to open and close your tub drain. You’ll need to repeat this step until it is working again. But if your tub is still draining slowly, you’ve probably missed some hair or debris. If so, you’re all done just reconnect all the parts. Test again to see if the water drains down your tub more smoothly. With any luck, the hair or debris that’s clogging your tub drain will be hooked onto the auger. When you meet resistance, start turning the hand auger clockwise while slowly withdrawing it. If so, you’ll need to feed a hand auger into the overflow hole and down into the drain. The vinegar and petroleum jelly work to (1) keep the parts from being sticky and hard to use, and (2) keep the parts protected and moving efficiently.Īfter you’ve cleaned the assembly, turn the water on and see if the tub still drains slowly.

Then dry the drain assembly and smear the plunger with petroleum jelly. Now that the trip lever drain assembly has been removed, clean the linkage (see photo above right) and plunger with a toothbrush and vinegar. Then gently (but firmly) pull out the entire assembly so you can clean it with vinegar and petroleum jelly. Remove the screws on the trip lever faceplate (this is also called an overflow plate). Now, simply remove the tub drain assembly out of the overflow hole. Once done, set the plate and screws aside. Start by removing the screws holding the overflow cover plate. The photos will help you visualize what you’re working with and how to follow along. How Do You Clean a Trip Lever Drain?įollow along with these quick three simple steps and your trip lever tub drain will be clean in no time.

The entire job shouldn’t take about 30-45 minutes. Aside from some vinegar and petroleum jelly stored in most households, you’ll also need: Replace the Trip Lever Tub Drain Assemblyįrankly, you won’t need much to do this job.

Removing tub overflow cover